Both Bambu Lab and Prusa Research introduced new printers they had been teasing for months, attracting large crowds eager to see the shiny new tech around their booths.

Yep not enabled at this point. Thus my caveat "when they deliver the slicer for that". They'd have to be working on it though. I'm walking that line myself. My next printer will very likely be either ...

Of all the parts on your average desktop 3D printer, the nozzle itself is arguably where the real magic happens. Above the nozzle, plastic is being heated to the precise temperature required to get it ...

So here's my problem: I want to change to a .6mm nozzle but when I do it appears that while the spacing of the paths the slicer makes assumes a .6mm line width the amount extruded is woefully ...

The potential for wearable electronics goes far beyond smart watches, but our current options for battery packs and circuit boards don't make for the most comfortable E-socks. One solution, being ...

Entrepreneurs in Denmark have taken another step towards improving the general usability of 3D printers with the Diamond Hotend, a single 3D extruder unit that can mix and melt three filaments ...

The Lathon 3D printer has two print heads that operate in sync for integrated two-colour or cross-material prints. Michelle Starr is CNET's science editor, and she hopes to get you as enthralled with ...

Some of you will be familiar with the idea of using a brush as a nozzle wipe on a 3D printer. The idea is that passing the hot end over the brush cleans any stray plastic from the nozzle, ensuring ...